6
HANGING THE FAN
1. Ensure
the
fixing
tab
fits
in
the
groove of the hanger ball. (Fig 3.)
2. Ensure the fixing tab is set at the highest point. (Fig 5.)
3. Suitable for installations up to 18 Degrees of Pitch. (Fig 4.)
FOR RAKED/SLOPED CEILINGS
Fig 3.
Fig 4
.
Fig 5
.
Light Cable
INSTALLING THE UPPER CANOPY
Align screws on hang
Bracket with keyholes
in 'upper canopy' and
twist clockwise into
position.
Tighten screws
gently and ensure
there is a uniform
5mm (approx) gap
between ceiling and
canopy.
Clip 'decorative screw cover' into place.
Note: For power supply,follow the wiring diagram Fig 6. (previous page)
1. “Clip receiver into
position on centre
strut of hanging
bracket”
2. Connect receiver
using quick connect
terminals to fan wire
terminals.
N/A for Models
"without Light"
Centre Strut
Once all the above steps have been followed, you are now ready to restore the mains
power supply.
Make sure there is nobody near or under the fan, then turn ON the fan (and light switch
if included in your model) to test.
Hang the assembled fan into the Hanging
Bracket making sure the groove on the
hanging Ball, locates into the Tab of the
Hanging Bracket. (Fig 3.)
Receiver Clip
