LOCATION
• The unit must be located and installed in accordance with AS/NZS 3000 and local building codes relating to damp situations.
• This may mean that no part of the Module may be located directly above any part of a bath or shower recess or enclosure.
•
The unit should be installed in flat ceilings with a minimum height of 2 metres. At least 200mm height clearance in the ceiling cavity
is required to ensure sufficient ventilation for moisture to disperse. The unit must also be installed at least 250mm away from walls.
•
Ensure adequate air intake into the room exists through windows, vents or under the door to replace the displaced air from the
exhaust fan.
•
Regulations concerning the discharge of air must be fulfilled.
POWER
AC220-240V ~50Hz electrical supply is required. The unit can be connected to a lighting or power circuit if loading permits. All
electrical work must be carried out in accordance with AS/NZS 3000 or latest edition thereof, and local building codes and regulations.
A five switch wall plate is included and must be wired as per wiring diagram supplied. Ensure the power supply is isolated before
commencing installation. Electrical wiring must only be done by a licensed tradesperson and a “Certificate of Compliance” must be
issued at completion of the installation.
INSTALLATION
1. Use the cut out template card as a template. Place in the required
location and mark out the hole cutting size: 528mm x 345mm.
Before commencing cutting ensure that the area behind the intended
location is clear of all cables, pipes and joists. Once clear, cut out the
section along the previously marked lines.
2.
Prise up the edge of fascia then take off the fascia. Take the LED
plug off the heater unit and remove cover of the terminal and connect
the wires according to the diagram. Connect the ducting to the unit if
required.
3. Insert the unit into the ceiling cavity, ensuring the clips are resting
against the body of the unit. Tighten the screws to ensure the unit is
fixed securely.
4.
Connect the LED plug to the fascia then attach fascia to motor body
making sure all fixing clips have located correctly.
Installation Instructions
Fan Heater, Light and Exhaust
Sahara
Electricians, please ensure a copy of the Installation
Instructions are left with the end user for future reference
Page 3 of 5
