background image

HEATFLOW 

Bathroom Heater/Exhaust/Light 204156/204157

HEATFLOW 

Bathroom Heater/Exhaust/Light 204156/204157

INSTALLATION INSTRUCTIONS AND HOLE-CUTTING TEMPLATE  435 x 275 mm

INSTALLATION INSTRUCTIONS AND HOLE-CUTTING TEMPLATE  435 x 275 mm

Fig.

 4

13.

Position the Bathroom Heater/Exhaust/Light unit into the hole, making sure 

the duct outlet is aligned with the exterior vent, ensure all cabling is away 

from the housing, and secure in place with the side spring clips. (Refer Fig. 4)

14.

Fix the housing into the ceiling using the four fixing screws. 

Note: 

Fixing screws included are for timber fixings only, for all alter-
nate fixing materials, appropriate screws must be sourced by the 
installer or consumer.

15.  Plug in the downlight and attach the fascia to the unit using the internal fascia 

retaining springs inside the housing.

16.  Install the bulbs until fit is secure, do not over-tighten or under-tighten.
17.

Clean the bulbs and fascia.

18.  Attach the switch panel to the wall.

Wiring Diagram

Note: 

This unit is fitted with a thermostat switch which will automati-
cally switch the exhaust fan ON, in the event the heat bulbs are 
left on, and the internal temperature exceeds 90ºC.     

Operation

Heat1: 

Heat2: 

Fan: 

Light: 

Turn ‘HEAT’ switch on/off. 

Switches two heat lamps on, do not touch while they are  

in use. 

Turn ‘HEAT’ switch on/off. 
Switches additional two heat lamps on, do not touch while they are in use. 

Turn ‘FAN’ switch on/off. 

The exhaust fan will extract the steam and odours quickly and efficiently.  

Turn ‘LIGHT’ switch on/off.

Turn the lights off when you leave the room.

Maintenance

Cleaning:

Turn the power OFF.

Wipe bulbs and fascia with care using a damp soft cloth with just a small 

amount of neutral detergent.

Bulb Replacement:

Check and tighten the bulbs regularly.

Turn the power OFF.

Use max. 4 x 275W E27 R125 Infrared heat bulbs.

ONLY use designated bulbs, other bulbs may cause damage or danger.

Warranty

EGLO offers the original purchaser a repair or replacement of the EGLO product in 

cases where the product fails due to defective materials or workmanship, when 

installed and operated under normal domestic/residential conditions for 3 years 

from the date of original purchase. Refer to the Warranty booklet enclosed with this 

product for further details.

Imported by:

EGLO LIGHTING AUSTRALIA

5/339 Archerfield Road

Richlands

Queensland 4077

www.eglo.com.au

Made in China

BY VENTAIR PTY LTD

4 CAPITAL PLACE

CARRUM DOWNS VIC 3201

SIERRA

PREMIUM HEAT, LIGHT AND EXHAUST

3 1

in

Ventair Pty Ltd offers original purchaser a repair or replacement of the Manrose 

product in cases where the product fails due to defective materials or workmanship, 

when installed and operated under normal domestic/residential conditions for 3 years 

from the original date of purchase. Refer to the warranty card for further details.

Отзывы: