DESCRIPTION
The VA100 from Vent-Axia is a 100mm extract fan for domestic bathrooms and WC’s
available as window, wall or panel mounted models. Model options with shutter, timer
and auto humidity control.
ACCESSORIES
(not supplied)
A range of 100mm wall and window kits are available for
installing into most walls/windows using telescopic
liners/spacers supplied.
A. INSTALLATION
WHERE TO FIT
A short circuit of the airflow should always be avoided by positioning the fan as far
away as possible from and opposite to the main source of air replacement. Fig. 1.
VA100LH, VA100XH and VA100XHT. These models are fitted with automatic
electronic humidity sensing. The humidity sensor needs free air circulation so do not
site close to cupboards, etc. Do not site above a radiator or other heat source.
PANEL/CEILING MOUNTING
IMPORTANT:
The fan should be installed into a closed duct system or protected by an
exterior air grille.
1.
Cut a 105mm diameter hole in the fixing surface.
2.
Remove the grille by loosening the screw at the bottom of the grille.
3.
Mark the screw centres through the holes in the fan back plate. Drill, plug and
screw into position.
4.
Replace grille and tighten the screw.
WINDOW MOUNTING (Window kit not supplied – see Accessories above)
1.
Cut a 105mm diameter hole in the glass.
2.
Fit spacers as required behind the fan back plate, engaging the locating pips in
the corner holes.
3.
Place the fan spigot through the hole in the glass from the inside, with a gasket
on each side of the glass.
4.
From the outside, place on the remaining spacer, with the locating pips facing
outwards. For double-glazing and materials up to 40mm thick, one or more
spacers may be discarded.
5.
Draw the assembly together with the threaded fixing ring. Do not over-tighten.
6.
Fix the exterior grille in position, using the screws provided, with the louvres
pointing downwards.
White
Brown
Window
254101A
N/A
Wall
254102
254100
Stock Reference