The alarm will initially emit an intermittent beep which increases in duration,
before progressing to a continuous beep, ending only when movement is
detected again. The selected delay is indicative only and begins following
an initial pause (approx. 15 seconds).
There are 8 function switches on the device which are normally turned ON
(upwards) during set up.
Figure 2: Alarm delay rotary switch (the alarm delays shown are approximate)
Figure 3: Side view of Venner DruGuardian
™
function switches
Alarm delay rotary switch
2.1.1
Function switches
2.1.2
ON (up)
OFF (down)
1
Alarm
Audible alarm is
turned ON
Audible alarm is turned
OFF, unit will still
collect open/close and
photographic data
2
Camera
Photos from the camera
are stored on the image
micro SD card
The camera is disabled
and no photos from the
camera are stored on
the image micro SD card
3
Data log
Door opening times and
alarm data are stored on
the data micro SD card
No information is
stored on the data
micro SD card
4
Volume
Alarm volume set
to Normal
Alarm volume low for
quiet locations
5
Re-program
Normal Operation
May be set to OFF for
additional security
6
Redundant
Normal operation
Normal operation
7
Redundant
Normal operation
Normal operation
8
Initial
assessment
Normal operation
The alarm function is
disabled for two weeks
in order to obtain base
line data. The alarm
function automatically
reactivates after the two
week delay.
Figure 4: Function switches
NB: Setting switches 2 or 3 to OFF will reduce battery usage.
The alarm delay rotary switch has 16 positions that determine the time delay
before the alarm commences. Using the small screwdriver provided, rotate the
switch until the dot is adjacent to the user required time delay.
Operative switches
2.1
Operating instructions
2.
7
6
