9
10
Tighten the screws so the charcoal unit is firmly attached to the
cupboard.
Remove the screw on the bottom of the hood and remove the
cover. Take out the adaptor.
*Be careful not to touch the electronic PCB.
7
8
Disconnect the outlet from the top using a hammer and screwdriver.
Punch out the power supply hole on the back of the range
hood. When installing a carbon module do not use the power
supply hole on the top of the hood to feed electrical wiring.
Make sure the power supply is on the right side of the hood.
Insert the electrical wire in the hole, ensuring the protective
bushing is in place (11 a).
Attach the hood to the charcoal unit using the holes with unem
bossed insertion slots.
Caution:
The electrical connection must comply with regional codes.
The appliance must be grounded.
a- The ground lead must be connected to the connector
installed on the range hood chassis.
b- The white lead must be connected with the white lead of
the power supply (neutral).
c- The black lead must be connected with the black lead of
the power supply (live).
It is recommended to use insulated wire connectors.
Install the five screws of the bottom cover using the four
additionnal screws available in the installation bag.
Slightly unscrew the air diffuser screws, remove it in order to put
the charcoal filter in place.
Remove the charcoal filter from the transparent plastic bag and
insert in charcoal unit.
Place the charcoal filter in the center of the unit.
Put the air diffuser and the filters back in place.
9
10
11
12
13
14
15
16
17
18
VENMAR
1
2
3
F
1 ¥ 2 ¥ 3 ¥ O
0 ¥ 5 min.
VENTILATION in
c.
VENMAR
1
2
3
F
1 ¥ 2 ¥ 3 ¥ O
0 ¥ 5 min.
VENTILATION in
c.
VENMAR
1
2
3
F
1 ¥ 2 ¥ 3
¥ O
0 ¥ 5 min
.
VENTILATIO
N inc.
6"
6"
30"
17
10
14
9
15
VENMAR
1
2
3
F
1 • 2 • 3
• O
0 • 5 min
.
VENTILATIO
N inc.
16
11
b
a
c
13
12
a
