VENMA Comfort S20, Руководство по эксплуатации и обслуживанию

Страница: 6 / 21

Ceramic gasket
Mounting flange (Optional for
extra charge)
VENMA Burner Manual
ST-976 Controller Manual
6.
Installation and first start-up
The burner should be installed by a person with appropriate
qualifications and skills. The manufacturer is not liable for
improper installation of the burner.
VENMA burners are intended for installation in central heating boilers,
but also for most gas or oil boilers. The position of the burner may vary
depending on the type of boiler, but the most common and recommended
installation method is the boiler door. When measuring the holes to be cut,
remember to take into account the need to operate the burner. Therefore, the
holes should be located in such a way so that after the installation, the boiler
door can be opened.
Mounting the device to a boiler prepared by the manufacturer is
relatively easy because the hole for the furnace and mounting holes are already
prepared.
If you want to adapt a normal boiler for the burner, carefully measure
the hole for the furnace and the mounting holes; the table below shows the
dimensions of furnaces and the spacing and size of mounting holes. Remember
that the selected burner should match the boiler power.
1.
Measure and cut a hole for the burner furnace, measure and drill holes for burner mounting bolts.
Fasten the burner to the boiler door by tightening the screws.
2.
Set the pellet hopper.
3.
Measure and adjust the length of the pellet feeder, bearing in mind that the angle between the
ground and the feeder pipe should not exceed 45
O . (See Fig. 2)
4.
Hang the feeder on a chain. (See Fig. 2).
5.
Attach the flexible 'spiro’ pipe to the burner and feeder. Please note that the pipe should not be too
long and the angle should not be too low, i.e. pellet in the pipe must go down under the force of
gravity (it cannot be suspended).
6.
Install the controller actuation module in any place, where it will not be exposed to direct heat from
the central heating boiler or pipes, as well as in a place where it will be freely accessible during later
operation.
7.
Attach the display unit and ducts to pumps, valves, etc.
8.
Install all sensors in the right places.
9.
Connect the cable connecting the controller to the burner.
6