Venini VEO9002, Руководство пользователя и инструкция по установке

Страница: 11 / 19

CLEANING THE APPLIANCE
Always allow the appliance to cool down before cleaning to avoid a burn injury.
Do not use caustic or abrasive agents, coarse wire wool or hard tools as these can damage the surface
finishes.
Normally, wiping with a soft cloth dampened with hot detergent is sufficient, but for stubborn marks the
following is recommended:
VITREOUS ENAMEL PARTS
Use only a cleaner that is recommended for this type of material – avoid chloride-based products such as
bleach. A non-caustic oven cleaner is recommended.
DOOR GLASS
Do not use any abrasive medium that could cause damage. Remember that if the surface of the glass panel
becomes scratched, this could lead to a dangerous failure.
To facilitate cleaning, the door glass can be lifted out after removing the fixing screws.
When refitting, make sure that the glass is correctly seated in the door recess and the correct way round.
Care must be taken when cleaning between the door glasses and inside the inner frame as some of the edges
maybe sharp due to the manufacturing process.
REMOVING THE OVEN DOOR
To facilitate cleaning inside the oven, the door can be removed as follows:
1) With the door in the fully open position, swivel the catch on each lower arm and clip over the hook on
each upper arm (see Fig.1)
2) Hold the door on each side, then lift to unhook the hinge mechanism and pull outwards to release from
the oven.
3)
To refit, hold the door in the fully open position and slide the hinge arms into the oven recesses until
the arms lock in position. On models with hinge mechanisms as per Fig.1, release the hinge clips and
close the door fully to complete the refitting.
WARNING
•
Take care not to dislodge the hinge lock system when removing the door as the hinge mechanism
has a strong spring system!
•
Do not immerse the door in water at any time.
Fig.1
9