Venini VCG60S, Руководство пользователя

Страница: 16 / 28

16
o
Carefully turn the hob upside down and place it on a cushioned
mat.
o
Apply the sealing strip (A) provided around the edge of the
appliance.
o
The protective covering must be removed from both sides.
o
Do not leave a gap in the sealing agent or overlap the thickness.
o
IMPORTANT: Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the hob
from the aperture in future if it needs to be serviced.
(A) Sealing strip
(B) Clamp
(C) Screw
o
Place the clamp (B) over the
holes that match the size of
the screws. There are one set
of screw holes in each corner
of the hob. Slightly tighten a
screw
(C) through the clamp
(B) so that the clamp is
attached to the hob, but so
that you can still adjust the
position of it.
o
Carefully turn the hob back over and then gently lower it into the
aperture hole that you have cut out.
o
On the underneath of the hob, adjust the clamps into a position
that is suitable for your worktop. Then fully tighten the screws
(C) to secure the hob into position.