How to install, operate and maintain your
Motorised Zebra Blind
Great Job… Enjoy
your new Veneta Blinds!
3
▪
240 Volt Rechargeable: Plug the charger unit into the 240-volt wall socket and insert the connector into the end of the blind tube to
charge. Charge time approx. 5-6 hours. Ensure you fully charge the motor for first use.
▪
Battery Pack: Position the battery pack in a suitable position and install the brackets using the screws provided.
▪
Place the battery pack into the clips and connect the battery tube to the blind.
▪
The remote is pre-programmed to the blind and ready to go.
Power Supply
▪
Use the remote to move the blinds up and down.
▪
Select left and right on the remote to change channels to operate a different blind.
Operating your Blind
▪
Dusting: Dust can be removed using a feather duster or vacuum with brush attachment on low
suction.
▪
Spot Cleaning: Use a warm damp cloth or a mild detergent for tougher stains.
▪
Dab the affected area, but do not rub the fabric. Finish with just a warm damp cloth.
▪
Allow the fabric to dry in the lowered position.
Maintaining your Blind
▪
Note: the remote control is already programmed to your blind and will work out of the box.
▪
If, however you need to re-
connect or set the limits, follow the instructions below…
▪
Connect Remote to Blind: Hold down the RED setting button at the end of the blind tube.
▪
The blind will move up and down slightly, then release button.
▪
On back of
remote, press the ‘C’ button.
▪
The blind will move up and down slightly and is now connected to the motor.
▪
Reverse Direction of Blind:
Hold both the ‘L’ button on the back of the remote and the ‘STOP’
button on the front of the remote at the same time.
▪
The blind will move up and down slightly and has now changed direction.
▪
Setting Bottom Limit:
On the back of the remote, press and hold the ‘L’ button.
▪
The blind will move up and down slightly and then move up and down slightly again, now it is
ready to set the limit and you can release the button.
▪
Press the ‘DOWN’ button on the remote.
▪
Allow the blind to run until you reach where you want to set the lower limit and press the
‘STOP’ button.
▪
On the back on the remote press the ‘C’ button.
▪
The blind will move up and down slightly.
▪
The lower limit is now set.
▪
Setting Upper Limit:
Press the ‘UP’ button on the remote.
▪
Allow the blind to run until you reach where you want to set the upper limit and press the
‘
STOP
’
button.
▪
On the back of the remote press the ‘C’ butto
n.
▪
The blind will now move up and down slightly.
▪
The upper limit is now set.
Remote Control
