Lifetime Limited Warranty
All Veneta
™
shutters have a lifetime limited warranty and will be free from defects in
materials or workmanship for as long as the original retail purchaser owns the shutters,
provided that such products were properly installed in residential dwelling; and such
products were made or assembled exclusively from original materials and components.
Any resale or other transfer of the product and/or materials voids this warranty.
For a complete copy of this warranty, please visit www.venetawindowfashions.com, or
contact customer service by email or phone.
Customer Service
1-855-558-1222
Email: [email protected]
Website: www.venetawindowfashions.com
Adjust the Tension System
Veneta
™
shutters are made to resist most staining substances and may be easily cleaned
by simply wiping down or dusting. For any stains or marks, a soapy water solution may be
used along with a damp cloth. Open the louvers and panels, and wipe down the front and
back of the shutters. You may also remove the panels from the frame and take down to
clean.
Maintain Your Shutter
If over a period of time the louvers on your shutters should
loosen or not function properly, a built-in tension system can be
adjusted. Simply open the panels fully and find the tension
adjuster screw hole on the side of each panel. Use a screwdriver
to gently turn the screw on each side of the panel to your desired
resistance level. Repeat process for other panel(s) if necessary.
Tension
Adjuster
Version 37103-64100
IMPORTANT: Check shutter operation and alignment before installing frame inserts, as
frame inserts can NOT be removed once they are snapped into place.
Match each frame insert with the corresponding side of the frame: Left to Left, Top to Top,
Right to Right, Bottom to Bottom.
Snap inserts into place. This will cover screws and provide a finished look.
Step 5 – Add the Finishing Touch
A rubber mallet can be used to help install frame inserts.
!
Step 4 – Attach the Panels
Open and close panels to make sure
panels operate properly. Secure the
frame with screws through the rest of the holes.
5.
Fasten the deadlock screw for all hinges.
6.
Please check the gap between panel and
frame at the top and bottom. The gap should
be even; if not, then shift frame left to right
until the gap is even.
3.
Place the left shutter panel in the frame,
align the hinges, and insert the hinge pin.
Repeat for the right shutter panel.
1.
If panel hinges are not aligned with
frame hinges properly, then frame hinges
can be adjusted.
2.
Once even, secure a screw at the bottom
of the left frame and right frame.
4.
!
