All rights reserved.
Copyright 2020 Vendlet ApS
MD
VENDLET must be used
and installed in accordance
with the manual
QUICK GUIDE
Ver
s. 1.0 - Oct
ober 2020
1. Fold the corner elastic straps around the mattress.
2. Check that the surface is smooth and even without folds. Make sure that
slippery side is facing upwards.
3. Fasten the velcro straps around the edge of the mattress support
platform. It is important that the straps are fastened around the
edge of the platform under the mattress and not around the bed
frame as this will prevent the back, thigh, and foot parts of the
bed from being raised.
ATTACHING THE SLIDE SHEET
VEND
LET
Standard
1. Place the turning sheet in the middle of the bed.
2. Press the edge strip of the turning sheet into the groove on one of the bars;
begin at the head end of the bed and work your way down to the foot end.
3. The turning sheet must always be placed OVER the bars to
prevent fingers, hair ect. of the patient from getting caught
under the sheet. If the sheet is placed under the bars, the pulling power will
be reduced and the motors will switch off when the turning sheet tightens.
4. Press the or button on the hand control and allow approx. two-thirds
of the sheet to be pulled in by the bar.
5. Press the edge strip at the opposite edge of the turning sheet into the groove
on the other bar.
6. Use this bar to pull in the turning sheet by pressing the or , button
until the sheet covers the mattress evenly with the red line at the centre of the
mattress..
ATTACHING THE TURNING SHEET W. QUICK TAG
Scan the QR code to
watch videos on how
to attach the sheets
+45 9631 0050 [email protected] www.vendlet.dk
