Vendlet 6300000, Руководство пользователя

Страница: 10 / 40

PART 1 - General information
10
BED AND MATTRESS COMPATIBILITY
VENDLET Standard is intended for mounting on a wide range of
hospital and care beds and with a wide range of mattresses.
The following bed and mattress requirements must be met.
Bed requirements
The bed must meet the EN 60601-2-52 standard or the expired
EN 1970 or EN 60601-2-38 standards.
The bed must have a square steel frame (dimensions H 45-78
mm, W min. 20 mm, L min. 1830 mm) without protrusions.
Inner distance between the head- and foot board must be at
least 200 cm. The bed width is not crucial as extra wide turning
sheets and slide sheets are available.
VENDLET Standard can be mounted on most beds with these
dimensions. But situations where VENDLET Standard cannot be
mounted can occur.
The maximum user weight and safe working load
of the bed must not be exceeded following the
installation of VENDLET Standard, see page 27.
Mattress requirements
The mattress must meet the requirements of the
bed manufacturers and be suitable for the bed.
The maximum user weight specification of the mattress must
not be exceeded.
Following the mounting of the VENDLET Stand-
ard, the distance between the mattress sides and
side rails must be minimum 2.5 cm and maxi-
mum 4 cm, see page 26.
If the mattress is soft and easily compressible,
it must be ensured that there is no entrapment
hazard due to extra compression at the edge of
the mattress.
When alternating air mattresses are used, it should be possible
to inflate the mattress to a firm state before VENDLET Standard
is operated. Soft mattresses will increase the friction against
the mattress and create an uneven base which will be uncom-
fortable for the client when VENDLET Standard is operated.
If the client changes mattress, the VENDLET
installation must be evaluated. A new mattress
might change the conditions and necessitate the
reinstallation of VENDLET Standard to reduce the
risk of entrapment.
WARRANTY AND SERVICE LIFE
Vendlet ApS provides a 2-year factory warranty on VENDLET
Standard. The warranty is void if the product is not used,
handled and maintained in accordance with the guidelines in
this manual. Opening the control unit, the bar, the corner post,
or the hand control will also void the warranty.
The warranty does not include the sheets.
The VENDLET Standard service life is 10 years. The service life
may be significantly extended if the product is used and
handled with care and maintained in accordance with the
guidelines in this manual.
The VENDLET Standard must be serviced annually by a person
with relevant training, see page 35.
IN THE EVENT OF AN INCIDENT
In case of an adverse event or a near-accident involving VEND-
LET Standard, the accident must be reported to the competent
authority in the country in which the accident happened and
to the Danish Health and Medicines Authority.
Likewise, Vendlet ApS must also be informed on phone
+45 9631 0050 or vendlet@vendlet.dk.