VENCO VC 416, Инструкция по установке и эксплуатации

Страница: 23 / 44

416298
H200
7-15-99A
9-29-00B
INST INSTRUCTIONS
VC 416/516
SUPERCEDES
TITLE DATE
SECTION
MANUFACTURING, INC.
III. Power Sources
B. Electric Double and Single Acting Pump Information
Note: Pumps should be mounted in the horizontal position. Check hose lengths when choosing
a pump mounting location.
See Dwg. 416080 (Fenner Double-Acitng) or 416306 (Monarch Double-Acting).
1. Position electric pump on truck frame, mark mounting holes on frame and drill through 7/16" dia.
holes (2 places). Mount pump to frame with 3/8"-16 x 1" hex head bolts (grade 5).
Warning
High pressure (3000 PSI) is developed by these pumps. Do not use hydraulic hoses that are
crimped, cut, abraded, worn or damaged in anyway. Replace hydraulic hose(s) if any damaged
condition exists. Use only hydraulic hose rated at a working pressure of 3000 PSI.
Use only steel fittings rated at a working pressure of 3000 PSI in the electric pump hydraulic
system. Replace the fittings if found damaged (bent, cracked, threads damaged, etc.). Do not
over tighten connections.
C. Double Acting Electric Pump Installation
1a. Attach one end of 7' hose to elbow at port "B" (rod end) of the hoist cylinder. Elbow fittings
are not required if 90° elbow ports are on the cylinder. Attach one end of the 5' hose to the
hoist cylinder at port "A" (full end). See Dwg. 416080 (Fenner Double-Acting) or 416306
(Monarch Double-Acting).
Note: The Monarch double-acting power unit does not require an external flow control (it is built
into the power unit).
b. Attach free end of the 7' hose to the swivel elbow on the pump at port marked "B". Attach free
end of the 5' hose to the flow control valve (Fenner power unit only) on the pump at port marked
"A" - on the Monarch power unit the 5' hose attaches directly to the pump port.
2a. Locate and attach electric pump switch and switch mount on truck dash.
b. Attach proper color coded wiring from switch to solenoid and in-line fuse to center posts and hot
lead under dash as shown. See Dwg. 416080 (Fenner Double-Acting) or 416306 (Monarch
Double-Acting).
c. Attach positive lead (#4 gauge) from positive terminal of battery to other large post on motor
solenoid. See Dwg. 416080 (Fenner Double Acting) or 416306 (Monarch Double-Acting).
3. Fill pump with commercial grade ATF-DEXRON II oil 1/2" from the top of the reservoir.