Page 9
MAINTENANCE:
-Clean front of lock with a mild damp cloth with detergent if needed.
-Do not use any hard or scratching cleanser.
-Do not clean with chemical materials that melt plastic (thinner, acetone, etc.)
-Be careful not to spill water on lock.
GENERAL WARNINGS:
-Read manual before using lock.
-Periodically check nuts and screws to be tightened.
-Do not over-tighten nuts or screws. Do not use an electric screw gun during
installation unless equipped with a torque adjuster.The maximum torque on
the cylinder screw is 2Nm.
-Set and test user and master password prior to installing the lock
-Change all default passwords with your own passwords.
-Common sense, but we must say it... Do not keep the passwords in the
cabinet where the lock is being installed!
-It is not possible to open lock if installed and you forget the user and master
password.
-Lock gives a warning beep when incorrect passwords have been entered
in repeatedly.
-Not possible for front side of lock to be opened by breaking or trying to force
open lock.
-Use CR2450 3.0V Lithium batteries.
-Remember that battery consumption is high
when programs 2, 3, and 7 are active.
CAMS:
-Two cams are included
-Cams can be placed at
increments of 90 degrees
-The Stop Cam (#4) in installation
instructions can be positioned for
turning the cam clockwise or counter-clockwise
OTHER:
Battery failure override- The miniK10 has 2 external nodes surrounding the red and
green indicator lights where an external battery can be connected long enough to
enter in the correct code to open the lock allowing new batteries to be installed.
ATTENTION!
In case of any failure, inform the vendor in writing of the detailed description of the
failure. In case of any intervention in the device, such as attempting to repair the
device, the device gets OUT OF WARRANTY.
Cam
Placement
7/8” Straight Cam
22mm
1-1/2” Straight Cam
38mm
