PTZ-BOX 5.0 User manual, document edition: 13
18
Declared by manufacturer IP class of housing protection will be maintained when the
gasket is properly seated and the housing cover is tightened.
2.3.3
Backup battery
The battery maintains backup of device’s crucial functions in case of discharge or replacement of
main battery. It allows to keep counting of LF pulses and working of real time clock while battery
replacement procedure is in place. The backup battery may be replaced by authorized service after
metrological seal is broken.
Only type 1/2AA LS14250 (Saft) or ER14250H (Fanso) backup batteries may be used.
2.3.4
External power supply
External power supply is required when using:
-
HF inputs.
External power supply is recommended for cases of high power usage:
-
frequent communications,
-
frequent screen usage,
-
NAMUR/SCR encoder.
Power supply is intrinsically safe type circuit, with intrinsic safety parameters given in paragraph 13.
External power supply of device should be connected to terminals 1, 2
–
according to indications on
wiring diagram. Parameters of power supply are described in paragraph 13.
The cables used must meet requirements for type B cables in accordance with standard EN 60079-14
–
in particular, wire insulation should withstand the test voltage 500 V AC and cannot be thinner than
0.1 mm (for insulation of polyethylene 0.2 mm).
Sealing of the unit
PTZ-BOX 5.0 as a device for billing, should be protected against unauthorized access. To do this, unit
housing is secured with seals like presented on figure below and access to the menu is protected by a
password system. Damage of any sealing marks causes loss of confirmation of
device’s metrological
features and certifications. Avoid damaging of seals during installation and operation of the device.
Installation staff is obligated to verify condition of seals before mounting of device. If the seals are
damaged, the proper functioning of device must be checked by the manufacturer authorized service.
Unauthorized opening of the device, mounting inconsistent with this documentation or
any changes to construction of the device can lead to loss of intrinsically-safe features
and/or metrological characteristics and/or radio equipment characteristics. Damage of
any sealing marks causes loss of confirmation of metrological, intrinsically-safe, radio
equipment features of the device.
