ISCOM073-1809
Mod.
VE LAN
User Manual
LAN TEST
Read all the instructions carefully
Tester for cables type RJ45, RJ11, UTP, FTP, STP.
Code Model
Description
VE772800
VE LAN
LAN TESTER
OPERATION
• Device Test
1. Plug one end of the tested cable into the transmitting RJ45 jack on the master unii
marked with a ‘I’ and the other end of the cable into the remaining receiving RJ45 jack.
2. Slide power swilch on. The upper row ol LEDs will slart lo scan in sequence if theAulo/
Manual button is set on “Auto” mode. The LED for pin 1 will light up if ihe button is in
“Manual” mode.
3. Switch back and forth from Auto or Manual scanning mode by pressing the Auto/Manual
button on the side of the master testing unii.
4. Once both ends of the cable are plugged in properly, the second row of LEDs will
illuminate according to the corresponding LEDs in the top row.
5. Read the results of the LED display for the pin configuration status of he tested cable. lf
you fai I to read the results the lirst time in Auto mode, you may wait for the second LED
scan, or simply switch to Manual mode for pin by pin testing. In Manual mode, pressing
the square “Test” button will advance testing to the next pin.
Note: Make sure the battery power is sufficlent. lnsufficlent battery power wi/1 lead to
dimmed LEDs and incorrect results.
• Coaxlal Cable Test
1. Plug the two attached BNC adapter cables on both RJ45 jacks. Then connect the tested
cable to each end of the BNC adapter cables
2. For the remaining testing procedures. please refer to steps 1.2 to 1.5
3. The center pin of BNC should be read on LED Please refer to
• RJ11 Modular Cable Test
1. Please follow directions for the UTP/STP Cable Test and refer to Diagram below,
for the correct LED pin out display.
2. Refer to the steps 2-5 of “Device Test”
Test Results
Description
1.
RJ45 Jack
2.
RJ45 Jack
3.
LED display for sourcing end (Jack 1)
4.
LED display for receiving end (Jack 2)
5.
Power switch
6.
LED scanning mode switch
7.
Test switch for manual scan
8.
RJ45 Jack
9.
LED display for receiving end (same as Jack 2)
10.
Ground LED for receiving end
11.
Battery compartment( (9V)
This symbol on the product and/or accompanying documents
means that used electrical and electronic products should not
be mixed with general household waste.
For proper treatment, recovery and recycling, please take this
product to designated collection.