Vemer TUO GSM VE771800, Руководство пользователя

Страница: 10 / 44

English
- 48 -
TUO GSM Chronothermostat User Manual
Once properly installed and powered, the device can be remotely controlled by sending
simple SMS messages.
For this to be possible, the sender of the command (SMS) must be registered on your
TUO GSM device.
It is also possible to send commands without being registered: in this case, however, it
is necessary to know the SMS commands protection password.
However, it is advisable to register at least one number in the phonebook.
This is because the device allows you to report any alarm situations (power failure or
exceeding a preset temperature) and, if they occur, it does so by sending an SMS to
one or more numbers saved in your phonebook.
On pages from 49 to 58 is described the procedure to memorize one or more numbers
in the phonebook of TUO GSM and the commands to be sent to control it.
GENERAL NOTES
A command SMS is structured as follows:
[password] [command] [parameter 1] … [parameter n]
- the words must be separated by one or more empty spaces
- the password can be omitted if the sender of the command is stored in the
phonebook
- it is possible to link several commands in a single message up to a
maximum of three
- to insert numbers with decimal part (ex. 12.6) the separator must be
the point (and not the comma)
- it is possible to write indifferently in lower case or upper case
If the command is correct, the sender receives a reply sms, whose structure is
similar to the command itself, with the addition of the symbol
“=” to indicate the
current status.
DEVICE REMOTE CONTROL