2
w w w . v e l o d y n e . c o m
SC-600D Amplifier User’s Manual
S C - 6 0 0 I W, S C - 6 0 0 I F / I C S U B W O O F E R S
SC-600 IW (In-Wall):
- Two high excursion 6.5” active drivers, two 12.5” x 3” oval passive radiators
with ribbed rubber surround
- High-excursion rubber surrounds on both active and passive drivers
- 2” 4 layer copper
- Frequency Response: 30 - 120Hz (+/- 3 dB)
- 4 ohm impedance
SC-600 IF/IC (In-Floor/In-Ceiling):
- 12” (9.7” piston diameter) subwoofer
- 2.5” 4 layer copper
- Oversized spider for linearity at high excursion
- High-excursion rubber surround
- Frequency Response: 25 - 120Hz (+/- 3 dB)
- 4 ohm impedance
Note:
The SC-600 IW and the SC-600 IF/IC must be driven with either the SC-600D or the
SC-602 amplifier. Use of any other power source voids the warranty.
Be sure to do the following to ensure the best performance from your subwoofer:
❑
If possible, optimize the placement of the subwoofer(s) in the listening area.
See page 10 of the User’s Manual.
❑
Install and wire the subwoofer per the instructions on pages 3 - 8.
❑
Select the proper model per the instructions on page 10.
❑
Select the proper volume level. See page 4.
❑
Be sure the low pass crossover is set correctly. See pages 8 - 9.
❑
Be sure to equalize the subwoofer using the microphone and Auto-EQ feature.
See page 11.
❑
Be sure to set the phase control on the remote. See page 11.
❑
Select the correct preset for the source material. See page 13.
Your new Velodyne subwoofer system provides for a number of installation options. Read all the
installation information below in order to determine which installation option is best for your
system. Remember to perform all installation procedures with system power turned off.
Note:
For proper setup and installation of the SC-600 IW (In-Wall) subwoofer, please refer to
the SC-600 IW Quick Install Guide.
S e t u p C h e c k l i s t