www.velodyneacoustics.com
User’s Manual
Deep Blue Series
6
Figure 1 shows the connections on the rear panel of the DB. Following are brief descriptions of the
connections described in Figure 1. More detail of these connections can be found below:
(1)
LINE INPUT
RCA jacks - Connect these jacks to the LINE OUT jacks of the amplifier.
(2)
LFE INPUT
RCA jack - Connect this jack to the LFE OUT jacks of the amplifier.
(3)
LFE OUTPUT
RCA jack - Connect this jack to the LFE IN jacks of an additional
subwoofer to daisy chain.
(4)
SPEAKER LEVEL INPUT
terminals - Connect these input terminals to the speaker
out- put terminals of your amplifier or receiver.
(5)
POWER INDICATOR
- Red: Unit is in standby mode. blue: Unit is in operation
mode. If there is no signal for eight minutes, subwoofer automatically goes into
standby mode.
(6)
Auto POWER switch –
Off: Unit is in standby mode. Auto: Unit is in operation
mode. If there is no signal for eight minutes, subwoofer automatically goes into
standby mode.
ON: Unit is on
(7)
VOLUME LEVEL
knob - Use this knob to adjust the output level of the subwoofer.
(8)
PHASE
knob - Adjust the position at which you hear a louder mid-bass sound.
(9)
LOW-PASS CROSSOVER
- Use this knob to select the high-frequency range at
which you wish to cutoff the signal to the subwoofer.
(10)
POWER SOCKET, Fuse Type:
T6,3AL 250V for
AC120V~60Hz T3,15AL 250V for AC230V~50Hz
(11)
POWER ON/OFF SWITCH
– Powers subwoofer on or off.
