Vello Freewave, Руководство пользователя

Страница: 7 / 20

7
The FreeWave supports 1 6,000,000
possible radio channels. The units have
been synchronized at the factory, so
your system can work right out of the
box. However, to maximize signal quality
and range, it’s best to use the Smart
Code technology to sense the “quiet”
frequencies in your environment and
re-synchronize on that channel.
Multiple receivers can be programmed
to respond to a single transmitter,
allowing you to trigger several cameras
with a single transmitter.
14 7
To synchronize the Transmitter
and Receiver(s):
1 . Turn on the Receiver(s) by pressing
and holding the Set/Power button
until the left red LED comes on.
2. Set the Receiver(s) to Ready and the
Transmitter to Single/Bulb.
3. Press the Set/Power button on the
Receiver(s) five times. The right LED
will begin blinking red.
4. Fully depress the shutter button on
the Transmitter. The right LED on the
Receiver(s) will blink and then turn off.
5. Your Smart Code is set and will
remain set to this code even after the
Receiver is turned off.
To test for synchronization, press the
shutter release button on the
Transmitter. If you press halfway, the
right LED on the Receiver will light
green. Pressing all the way will turn the
LED red. If you don’t see this
confirmation, re-synchronize the units.
1 . Power up your camera and set it to
Continuous Mode. The Receiver
does not need to be on, but because
the Receiver does not need power in
wired mode, the LEDs will not light.
2. Set the Receiver switch to Ready.
3. Press the shutter release button
halfway to wake or focus the camera
(if set to Auto Focus).
The confirmation LED will not
display, so be sure to focus manually
or allow the camera to Auto Focus
without confirmation.
4. A full press of the shutter button will
trigger the camera to take
continuous photos until you release
the shutter button.
You can also take continuous photos by
moving the Receiver switch to the
Hold position. The camera will take
photos until you move the switch back
to the Ready position.
CONTINUOUS MODE | WIRED SETTING THE SMART CODE