VelLight LEDA54CW, Руководство пользователя

Страница: 8 / 32

LEDA54CW
V. 03 – 07/09/2015 8 ©Velleman nv
6. Powering your PIR Light
Refer to the illustrations on pages 3, 4 and 5 of this manual.
6.1 Inserting the Batteries
Insert the batteries (not included) according to the illustrations below:
1. Open both battery compartments [1a] .
2. Place the batteries in the battery compartments. Mind the polarity
[1b] .
3. Close both battery compartments [1c] .
6.2 Recharging the Batteries
Recharge the batteries using a compatible phone charger (not included) or a
computer (not included). Connect using a compatible connection cable (not
included) [2] . Make sure to use rechargeable batteries.
7. Installation
7.1 Installation with Double-Sided Tape
1. Make sure the installation surface is dry, smooth and grease-free.
Clean with a cloth and dry if necessary. Tear off the protective film
from both pieces of tape and apply them on the mounting bracket
[3a] .
2. Tear off the protective film from both pieces of tape and glue the
mounting bracket onto the mounting surface
[3b] .
7.2 Installation on a Wooden Board
1. Choose your installation spot.
2. Place the mounting bracket against the board and drill the included
KA3x10mm screws into the board
[4a] .
3. Fix the light to the bracket [4b] .
7.3 Installation on a Concrete Wall
1. Choose your installation spot.
2. Drill two holes using a masonry drill bit (not included) and insert a
nylon plug in each hole. Refer to the illustration below for the
measurements
[4c] .
3. Fix the light to the bracket using the included KA3x18mm screws
[4b] .