LEDA301/302/303
V. 01
–
15/03/2013
7
©Velleman nv
Distances
Keep the device at least 20 cm away from ceilings or walls.
Respect a minimum distance of 1
m between the device’s light
output and any illuminated surface.
Mounting the lamp
1.
This luminaire does not have a built-in device to disconnect it
from the electric mains. Make sure to electrically isolate the
luminaire before installation or maintenance activities are
performed.
2.
Use the mounting bracket
[1]
to determine the location of the
mounting holes.
3.
Drill the holes and secure the bracket using screws and wall
plugs.
4.
Connect the power cable to a suitable junction box (not incl.).
Make sure the connection is properly earthed. Make sure there is
no strain on the cable; leave sufficient slack.
Warning
: if the power cable is damaged, it must be replaced by
the manufacturer, his service agent, or a similar qualified person
in order to avoid any hazard.
5.
To point the lamp in the desired direction: loosen the hinges
[2]
using a spanner.
6.
Tilt the lamp in the desired angle and tighten the hinges.
7.
Cleaning and maintenance
All screws should be tight and free of corrosion.
The housing, the visible parts, the mounting supports and the
installation location (e.g. ceiling, suspension, trussing) should not
be deformed, modified or tampered with; e.g. do not drill extra
holes in mounting supports, do not change the location of the
connections…
Mechanically moving parts must not show any signs of wear and
tear.
The electric power supply cables must not show any damage.
Have a qualified technician maintain the device.
If the protective glass
[3]
is damaged, disconnect the lamp
immediately from the mains. Have it repaired immediately by a
qualified technician. Do not use the lamp with a cracked or broken
protective glass.
