WB025
Rev. 01
29/04/2011
©
Velleman nv
4
User manual
1.
Introduction
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer.
2.
Safety Instructions
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
•
Damage caused by user modifications to the device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
•
Check the contents prior to assembly. Use proper tools and never use defective or deformed parts
as an improper installation may cause serious injury.
•
Any included hardware is
for mounting on solid brick, concrete
or
hard wood battens
.
When mounting on wood, do not use any concrete anchors. Do not use any included hardware for
mounting on steel. If uncertain about the nature of the wall or mounting techniques, please
consult an expert.
•
Respect the product’s max. load specifications. Protect this device from shocks and abuse and
avoid brute force when operating. Check the installation on a bimonthly basis.
•
An adequate mounting is essential and falls outside the responsibility of Velleman nv. Respect all
installation and operating directions of the device to be mounted/installed (LCD/plasma display).
•
Only use the device at an indoor location, protected from rain, moisture, splashing and dripping
liquids. Make sure the chosen location spot is able to support the weight of the bracket and
screen.
•
Keep fingers away from articulations to avoid injury. Keep the device out of reach of children and
unauthorized users at all times.
3.
General Guidelines
Refer to the
Velleman® Service and Quality Warranty
on the last pages of this manual.
4.
Features
•
for A/V equipment
•
2 shelves - position adjustable
•
easy installation
•
comes with all necessary plugs and screws for assembly and mounting
•
with cable guides
5.
Installation
Refer to the illustrations on page
2
and page
3
of this manual.
1)
Close the bottom cover and slide the cable guides top-down into the foreseen openings in the
mounting bracket.
2)
Use the wall mounting bracket to determine and indicate the position of the mounting holes.
2a)
When mounting on a brick or concrete wall, drill holes size Ø8mm, at least 50mm deep at the
indicated positions and insert anchors
[D]
. Fix the wall mounting bracket against the wall
using 6 screws
[C]
.
2b)
When mounting on a wooden wall or wall support, drill holes size Ø3mm, at least 50mm deep
at the indicated positions. Make sure all the holes are blind holes. Fix the wall mounting
bracket against the wall using 6 screws
[C]
. Do not use anchors!
3)
Attach the supporting arm to the bracket joints using 2 screws
[A]
.
4)
Mount the shelf on the supporting arm using the included bolts
[B]
and washers
[F]
and the
included nut
[E]
.
Never
use the wall support with loose shelves.
5)
Slide the shelves with the bracket joint under an angle into the wall mounted bracket
(1)
and
push it down until a click is heard
(2)
. Close the top cover.
6)
Move the shelves to the desired position.
7)
Secure the shelves’ positions by tightening the safety screws with the included hex wrench
[G]
.
DO NOT
use the wall support without the safety screws securely in place.
