Velleman vm118, Руководство пользователя

Страница: 9 / 12

9
4) Force the remote/relay card to address 1.
If the receiver has been set to an address other than 1..8, you can force it to respond to address 1.
Attention : All active cards will respond to this command (except when the ‘remote control’ jumper on the relay card is
set to ‘off’). Press ‘shift’ to leave the set-up mode.
You can leave the 'set-up' mode at any given time by pressing the 'shift'-button repeatedly until the LED turns off. If no button
is pushed for a while, the unit will leave the 'setup'-mode and the LED will turn off.
Setup