PI1000M GB
2
4. FUSE
Please check the fuse of your installation if the voltage indicator is not lit during operation.
Replace a blown fuse with an identical one.
Fuse : 1000W. Max. 30A x 4 for a 12V inverter or 20A x 5 for a 24V inverter. This device is
equipped with an INTERNAL fuse.
5. OUTPUT
CAPACITY
The inverter will switch off automatically if the total wattage of the electrical appliances
connected to the inverter exceeds the inverter's output capacity. This will also happen if the
temperature of the inverter exceeds 55°C due to prolonged use.
6. SPECIAL
RECOMMENDATIONS
Unplug the AC inverter when not in use.
Unplug the AC inverter before starting the vehicle's motor.
If the AC inverter makes a beeping sound : switch off the appliance, unplug the inverter and
restart your vehicle's engine. The beeping sound is simply the low-battery warning, which
indicates that the voltage of your battery is getting low. Your inverter will shut down
automatically if you do not restart your engine and continue the use of your inverter. This will
leave your vehicle's battery at about 10.5VDC, enabling you to start your engine and resume
operation of the inverter. It also eliminates the possibility of being stranded with a dead battery.
You can avoid over-discharging of the battery by letting your engine run for 10 to 20 minutes for
every 2 to 3 hours of using the AC inverter. This will allow your vehicle's battery to recharge.
Please remember to connect the "+" wire to the "+" terminal and the "-" wire to the "-" terminal if
you elect to use an adapter for a direct connection between the AC inverter and the battery
terminals. IF YOU CONNECT THE WIRES TO INCORRECT TERMINALS, THE POLARITY
WILL BE REVERSED AND THIS WILL DAMAGE THE INVERTER. REVERSED POLARITY
WILL INSTANTLY VOID THE WARRANTY.
Please remember to disconnect the AC inverter before using the battery charger to replenish
the voltage of your battery. Failure to disconnect the inverter prior to connecting a charger may
result in an input spike that will damage the inverter.
CONNECTING THE INVERTER'S INPUT TO A BATTERY CHARGER WILL VOID THE
WARRANTY AND MAY DAMAGE THE INVERTER.
Make sure that the battery's voltage never exceeds 15VDC.
CONNECTING THE INVERTER TO A DC POWER SOURCE GREATER THAN 15VDC WILL
VOID THE WARRANTY AND MAY DAMAGE THE INVERTER.
IMPORTANT : DO NOT CONNECT ANY INDUCTIVE LOADS WITH THIS DEVICE !!!
