PCWSB1
2
VELLEMAN
b. Receiver
Front panel (left)
1. power/tuning indicator
2. volume control
3. power button
4. tuning wheel
Side panel (right)
5. headphones connector
6. 9Vdc power input
c. Operation
1. Transmitter
•
Connect the device to your computer by means of the enclosed USB cable and set the switch (p.1 #6) to USB
•
OR connect the device to an audio source with the enclosed RCA cable, set the switch (p.1 #6) to "BATT/ ADAPTOR" and
insert 4 AA batteries (not incl.) in the battery compartment at the bottom
•
OR connect the device to an audio source with the enclosed RCA cable, set the switch (p.1 #6) to "BATT/ ADAPTOR" and
connect the device to the mains by means of a 6V/100mA regulated power adapter (not incl.).
•
Put the antenna upright, set the tuning wheel to the middle position and start the audio source.
2. Receiver
•
Put 6 'C' batteries (not incl.) in the battery compartment at the bottom of the receiver or connect it to the mains by means of a
9V/1A regulated power supply (not incl.).
•
Switch the receiver on (p.2 #3), the power/tuning indicator lights up.
•
If it is green, the receiver should receive the signal ; set the volume control to the desired level.
•
If it is red, search for the signal by means of the tuning button. If the power/tuning indicator turns from red to green, you have
found the signal ; set the volume control to the desired level
3. Fine-tuning
•
For optimal tuning, transmitter and receiver should be approx. 15 feet apart.
•
Pause the audio source and further tune the receiver so the background noise is reduced to a minimum.
•
Put the receiver in the desired location, resume audio playback and adjust the receiver volume.
•
Note: the longer the distance, the weaker the signal and the stronger the interference.
6. Troubleshooting
no sound
- Check if the transmitter is switched on (power indicator is lit)
- Check if the receiver is switched on and is receiving signal (power indicator is green)
- Check if the audio source is switched on and emitting signal (also check the cable)
- Check if the receiver volume control is not set to the minimum
interference,
distorted sound
- Check the condition of the batteries
- Check if the transmitter antenna is upright
- Check if the audio source itself is clear and undistorted
- Fine tune the receiver to reduce the background noise
- Check if the problem does not solve itself by changing the transmitter and/or receiver location
- Change the tuning setting of the transmitter and adjust the tuning of the receiver accordingly
The information in this manual is subject to change without prior notice.
