LABPSHH01
V. 03 – 28/10/2016
5
©Velleman nv
5.3
Keypad
key
description
Press the
STORE/RECALL
button to store/recall a pre-set
value to/from the memory bank.
V/A
Press
V/A
to switch between the current and voltage
measurements.
Press the
USB
button to enter the USB power-charging
mode. Adjust the voltage to 5.2 V and the current to 3 A.
Press the
OUT
button to use the device as power charger.
Press the
USB
button again to exit the function.
Press the
OUT
button to put the power supply in output
status and read the current and voltage values on the
display. Press again to exit the function.
Press the
UP
button to activate the backlight.
Press the
DOWN
button to deactivate the backlight.
Press the
LEFT
button to decrease the display contrast.
Press the
RIGHT
button to increase the display contrast.
SET
Press
SET
and adjust the values with the arrow keys. Press
V/A
to switch between current and voltage.
5.4
Basic Operations
Voltage and Current Setting
1.
Connect the device to the mains.
2.
Press the
OUT
button to deactivate the output mode.
3.
Press
V/A
to select the voltage or current mode.
4.
Press the
SET
button to enter the setting mode.
5.
Press or to select the digit, adjust the selected value with or .
6.
Press
SET
to confirm your setting.
REMARK
It is possible to set the voltage or current once the
outputs are valid. However, for the protection of
the load, it is recommended to stop the output
before voltage or current setting.
Due to the total power limit, current settings might
be decreased automatically once the voltage
setting is increased.
Содержание LABPSHH01
Страница 2: ...LABPSHH01 V 03 28 10 2016 2 Velleman nv ...
