Velleman K8063, Инструкция по сборке

Страница: 9 / 20

9
Test
When the assembly has been completed, we recommended to test each
individual unit before daisy-chaining them. Make sure SK7 (address jumper) is
put in place, see figure 4.0.
Connect a 9 to 12VDC power supply to the pins GND and +V.
At power-on, the K8063 will display .0123456789 (segment test).
Next, it will display its current address (default : 1) for a couple of seconds.
At this time, the K8063 allows you to select an address ranging from 0 to 19*.
Simply wait until the desired address is displayed and remove the SK7
address jumper. ( note : addresses 0 to 9 are displayed as 0 to 9, addresses
10 to 19 are displayed as 0. to 9. (note the dot).
The K8063 will loop the addresses until the jumper is removed, so if you have missed the desired address,
you can wait a while and it will appear again.
Once you have removed the jumper, the K8063 stops looping and after a couple of seconds the display will
turn blank. The selected address is now stored in its memory.
*If you require 20 or more different addresses, you can configure them when the K8063 units are hooked-up
to the computer (see further in this manual).
14. Test
Fig 4.0