CAMTVI7N1/CAMTVI7WN1/CAMTVI8N1/CAMTVI8WN1
V. 01 – 27/02/2017
5
©Velleman nv
Connect the video connector to a monitor (not incl.) or a sequential
switcher/quad splitter (not incl.) in case of multiple domes.
Connect the power connector to a 12 VDC power supply (not incl.).
Set up the desired field of observation by adjusting the position of the
lens enclosure in the positioning ring.
For the CAMTVI8(W)N1, manually adjust the zoom and focus with their
screws. The location of the screws can be determined by looking at the
position of the light sensor.
Tighten the fixation ring to secure the camera’s position.
7.
OSD Settings
There is a small joystick in the camera cable that allows you to adjust the
settings of the camera using an on-screen display (OSD).
Press the middle button to access the menu, or
to select an option.
Press the up and down buttons to move up and
down in the menu.
Press the left and right buttons to modify the
menu parameters.
In the OSD menu:
NEXT/BACK:
select this option and press the middle button to go to the
next/previous page of options in the menu.
RETURN:
select this option and press the middle button to return to the
previous level in the menu.
EXIT:
select this option and press the middle button to leave the OSD
menu without saving the settings.
SAVE ALL:
select this option and press the middle button to save all
settings.
CAMERA RESET:
select this option and press the middle button to reset
the camera to the factory defaults.
The OSD menu settings are described in detail below.
Refer to the table on the final pages of this manual.
