4
VM206
USER MANUAL
Plugging in your board for the first time
First, you will need to plug your VM206 into an available USB port on your computer so Windows can
detect your new device.
Then download the latest software version for the VM206 on
via these simple steps:
1. go to:
http://www.vellemanprojects.eu/support/downloads/?code=VM206
2. download the VM206_setup.zip file
3. unzip the files in a folder on your drive
4. double click the “setup.exe” file
An install wizard will guide you through the complete installation procedure. Shortcuts to the VM206
software can now be installed.
fig. 1
Starting the software
1. locate the VM206 software shortcuts
(programs > VM206 > ...).
2. click on the icon to start the main program
3. then click on the ‘Connect’ button,
the “Connected” label should now be
displayed
You are now ready to program the VM206 timer!
Timer operation modes
1: on delay - relay turns on after delay t1
2: off delay - relay turns off after delay t1
3: one shot - a single pulse of length t2, after delay t1
4: repeat cycle - after delay t1, relay turns on for t2 ; then repeats
5: repeat cycle - relay turns on for time t1, off for t2; then repeats
6: toggle mode
7: start/stop timer
8: staircase timer
9: trigger-at-release timer
10: programmable timing sequence
Now you can set up your first timing program for the VM206:
1. select any of the options from 1 to 9
2. enter the time or use the default 2sec and 1sec
3.
now click the ‘Send’ button
