Operating model : Dark - ON
Operation :
Output circuit
n
INSTALLATION
1. Move the sensor up/down and left/right opposite the reflective target and set it at the
center between the positions where the Operation LED is off each direction.
2. Setting the Sensitivity Adjustment volume according to detectable distance and
object.
3. Using several sensors, install them at 30 cm (12") intervals.
4. When the target is glossy or highly reflective, place the sensor and the reflector at
an angle of 30°~45°.
n
PRECAUTIONS
l
When cleaning the lens and the case, use a dry cloth and gently wipe the surface.
Do not use solvents such as thinner or alcohol.
l
Avoid continuously switching the power source on and off.
l
Relay exchange is not available, but use servo relay. In case of prolonging life for
relay, please set surge absorption component (Condenser and so on).
l
Although this sensor is waterproof, you cannot use the sensor where direct water
spray continuously occurs, or under water.
l
Power supply should be shut off before wiring operation.
l
Do not run sensor cables parallel to high-voltage lines or power lines, nor put them
together in the same raceway.
l
Wiring length is 100m max.
l
Avoid places where the beam sensors are exposed to direct fluorescent lights with
the rapidstarters of high frequency starters.
