VELGE Rodoy, Инструкция по установке, эксплуатации и обслуживанию

Страница: 7 / 17

www.velgehome.com
allowing a complete disconnection on the conditions of the overvoltage
III category, according to installation regulations. The ground connection
(yellow-green wire) must not be interrupted.
Refer to the plate inside the hood for the mains voltage and frequency
ratings.
USE
This cooker hood can be employed as exhausting or filtering.
Exhausting (external evacuation). Kitchen smokes are driven outside
through a flue joined to the exhaust pipe flue connector.
This pipe must not under any circumstances be connected to cooker,
boiler or burner exhaust pipes, etc.
Filtering (inside recycling). In this case it is essential to install the
activated carbon filters on the motor Smokes pass through the activated
charcoal filter (Picture 3 –D) to be cleaned and recycled in the kitchen
environment by means of holes (E) from which the purified air will come
out. These holes have to be free and communicating with the kitchen
environment.
In this case you should not install the exhaust pipe without curve.
OPERATION
VENTILATION
The hood is supplied with a multispeed motor.
The hood should be run at low speed under normal conditions and at
higher speeds only when there is a heavy build-up of fumes or odours.
and then kept on until all odours have been eliminated. The controls
consist of these commands. Press to turn on the light, press 0-1
to swich on the hood at first speed and to switch off the aspirator,
hob. If the mounting instructions of the gas cooker indicate a wider
distance, respect it. The unit must not be mounted above cookers fitted
with top radiant plate.
Respect all the air discharge regulations.
The air must not be discharged in a pipe used to discharge exhaust fumes
produced by gas-fed equipments or fuel-fed equipments (this does not
apply to filtering hoods).
The room must be adequately ventilated when the hoods is used together
with other gas- fed or fuel-fed equipments.
For an easy access, it is advisable to move possible furniture under the
installation area.
Installation of the hood onto the wall.
The hood is equipped with all the necessary fastenings for its installation,
which are suitable for most surfaces. Anyway ask a professional to verify
that the installation surface is strong.
Installation must be carried out by qualified installers according to
present regulations.
First, provide for the installation of the speakers as shown in (Picture 4) .
After having drawn and drilled the wall as in (Picture 2) , use the following
fastenings for installation:
•Blocking dowels (A)
•Suspending and levelling dowels (B)
•Brackets and screws for fixing the chimney to the wall (C)
ELECTRICAL CONNECTION
This equipment must be connected to a grounding plant. Two types of
electrical connection can be used:
1)Using a standard plug to be connected to the power cable and inserted
in a mains socket which must be accessible (so that the plug can be
disconnected when servicing is carried out). Make sure that the plug is
accessible also after the complete installation of the equipment.
2)By means of a fixed mains connection, fitting a bipolar switch, which
ensures the disconnection, with an opening distance of the contacts