- 13 -
6.6.
Fasten the door holder No.
49
to the right crosspiece of the end
with self-tapping screws No.
46
, and fasten the hinge of the door
holder on the lower door lintel for the holder to fix the door in the
open position (see the figure above).
6.7.
Insert door handles from set No.
48
to Ø12 apertures in the doors
(be sure to pre-drill relevant holes in polycarbonate). Put the catch lock
and cover plate on the backside, fasten the handle and cover plate with
self-tapping screws No.
46
.
6.8.
Fasten door latch No.
51
with self-tapping
screws No.
46
from inside between the lower
and upper doors, so that the doors can be locked
up with each other. For this purpose, unscrew
the self-tapping screw in the door corner, mount
the latch, and tighten the self-tapping screw
again.
7. POSITIONING OF CELLULAR POLYCARBONATE ON THE ROOF
IMPORTANT!
Prior to positioning Polycarbonate on the roof, make certain that the
frame geometry is correct.
Diagonal distance between the frame angles must be equal.
Longitudinal stringers must be straight, free from curves and skewing.
Be sure to remove the wrapping film from both sides of the sheet.
The manufacturer marks the work face (sunward) of cellular
polycarbonate with a certain mark (a color bar, sticker or other).
Polycarbonate cellular lines must be located along the frame arches of
the greenhouse.
