Velbus VMBKP, Руководство пользователя, Страница: 18 / 44

VMBKP
18
Velbus – Legen Heirweg 33, BE-9890 Gavere, Belgium – tel. +32 9 384 36 11 – e-mail: info@velbus.eu – www.velbus.eu PN-VMBKP-ed1-A4
LOCATION PARAMETER DEFAULT FUNCTIONS & VALUES
7 1 Notification Tones ON-OFF
Selection Code = 1, Notification Tone ON
7 2 Channel State Announcer Code = 1 Sec, Notification
Beep ON
7 3 Status LED Standby Flashing
ON-OFF Code = 1, Flashing Enabled
8 0 Door Forced Open Warning Code = 0, Warning Disabled
8 1 Door Propped-up Warning Code = 0, Warning Disabled
9 0 Egress Mode, Delay, Warning
Beep and Alarm Code 1 = 0, Instant, No Delay
Code 2 = 1, Momentary
Contact without Warning
NOTE:
The DAP Code 2 8 2 8 and the Refreshing Code 9 9 9 9 are fixed in the operating system. They can not be changed in
any way.
Master code (Location 01)
Location Master code Validation
0 1 4 to 8 digits #
1. Location
•
Enter Location 0 1
2. Master code
•
The Master Code is the authorization code for setting the system to programming mode. It is NOT a User Code
operating the User Group channels.
•
The Master Code can be 4 to 8 digits long.
•
When a new master code is entered and confirmed, the old master code is replaced.
3. Validation
•
Press the # key once. A double beep confirms the entry.
Example:
Set the Master Code to 2 2 3 3: 0 1 2 2 3 3 #
Super user code (Location 02)
The Super User Code has two functions:
1. It allows hardware inhibition
2
to be paused manually.
2. Using the Super User Code, the User Group channels can be activated even when hardware inhibition
2
is active
Location Super user code Validation
0 2 4 to 8 digits #
2
cfr. “O/P 1 INH (User Group 1 Inhibit Control Input – Normally Open)” on p.8