Installation Manual VMBEL-series
VMBGP-series
Jan 2024
Page
6
of
6
6.
Removing the Velbus control panel
To remove the Velbus control panel, hold both sides of the panel with your hand and firmly pull
the panel towards you. You may find that starting at one corner is easier, but do not pull
excessively.
Do not use tools to pry as they might damage the onboard temperature sensor!
7.
Alternative connection technique for the EIB cables.
Since the recommended bus cable is a solid core grade cable with 4x 0,8 mm diameter, it might
be rather sturdy and difficult to mount the Velbus control panel, especially when using an arriving
and departing cable.
To this end, we have included a WAGO push connector for the four
bus cable cores. This connector can be placed inside the wallbox,
allowing you to bring only four wires towards the Velbus control
panel instead of eight.
NB.
Never use excessive force, for example when mounting plates, locating lugs or any cable
connections. Use a release tool on the spring clip connectors if you need to relocate or otherwise
move a cable core.
Excessive force will break a part that can then
no longer be returned
under warranty!