VeinSight VS500, Руководство пользователя

Страница: 12 / 28

VS500 VEIN FINDER USER GUIDE
10

Power: Power button.
Press Power button for about 0.5 seconds till two beeps are heard, then the VS500 will
be power-on.
Off: Press and hold Power button for more than 2 seconds till two beeps are heard and
the light of Power button goes out, then the device shuts down.
Standby: When device is power-on and the projector is light-up, short press the Power
button (no more than 0.5 seconds) to enter the standby mode and the projector will be
turned off.
Wake Up: When device is in standby mode, short press the Power button (no more
than 0.5 seconds), the device will beep and the projector will be light-up.
❸
Short press this button to change the projection color. There
are five colors to choose from, including cyan, green, skin
color, red, and blue. The default color is cyan.
Long press this button to inverse the vein image. The
projection of the vein is dim by default.
❹
Short press this button to switch between the universal mode
and enhanced (fine detail) mode.
Long press this button to switch to depth mode.
❺
Short press this button to adjust brightness. There are 5
degrees of brightness.
Long press this button to change size of vein image: full size,
2/3 size and 1/2 size. The default size is full size.
❻
Short press this button to freeze the image, then long press
to save the image, and an image number will appear in the
upper-left corner as shown in the picture below. Short press
the button again to go back to default mode. In freezing,
short press the button will not save the image, and the device
will go back to default mode.