Smart-MC0101 / User Manual
8
Revision
№
01
- 14.09.2017
INITIAL STARTUP
Door and window sensor is powered by the CR123A 3V 1400 mAh replaceable battery.
You need to insert the battery observing the polarity before start.
The sensor supports two activation methods in the LoRaWAN network - ABP and OTAA.
Select one of the methods using “Vega LoRaWAN Configurator” application (See part 4).
1. ABP. After pressing the start button, the device immediately starts working in the
"Active" mode.
2. OTAA. After pressing the start button, the device makes three attempts to connect to
the network within the set frequency band. After the activation request is confirmed by
LoRaWAN network, the device sends a signal and switches to the "Active" mode. If all attempts
fail, the sensor switches to the “Storage” mode.
To manually switch the device from the "Active" mode to the "Storage" mode, you can
use the long press of the start button (more than 5 seconds).
Before connecting the device, make sure that its registration data is
entered in the network - Device EUI, Application EUI and Application
Key for OTAA, or Device address, Application session key and
Network session key for ABP
Insert the battery
CR123А into the
battery
compartment
Press the start
button located on
the board
