VeEX VePal TX130M+, Руководство пользователя

Страница: 102 / 175

13.4.2 Results
Current TIE:
Shows the last Time Interval Error (relative phase error) measured between the reference clock and the test signal.
Max TIE:
Records the maximum TIE value measured since the test was started.
Min TIE:
Records the minimum TIE value measured since the test was started.
MTIE:
Shows the maximum difference between TIE values measured since the test started (Max - Min)
Note: The wander tests will automatically stop if either of the signals used as reference clock or recovered clock (test signal)
have significant levels of impairments, are lost, or disconnected.
Press the Stop button to terminate the test. If Save TIE to USB is set to ON, then remove the USB memory stick from the test
set, bring it to a computer, and open it with the VeEX Wander Analysis PC software, for further MTIE, TDEV, and masks analysis
(refer to the MTIE and TDEV Analysis section).
Both, Wander Analysis and MTIE / TDEV Post Analysis are optional features.
1588v2 Wander Measurements Setup and Results
Go back to top Go back to ToC
_e-manual_D07-00-051P_RevD00