VeEX UX400, Руководство пользователя

Страница: 66 / 209

RFC2544 Frame Loss Settings
Go back to top Go back to TOC
Burst (Back-to-Back):
The following parameters can be configured:
Max Rate:
The default value is 100%.
In the burst test, frames are always transmitted at the maximum rate for a given minimum and maximum burst duration.
Minimum Duration:
Selectable in the range 2 to 999 seconds. Default value is 2 seconds.
This is the duration of the first burst.
Maximum Duration:
Selectable up to 999 seconds. The default value is 20 seconds.
This is the duration of the second burst, which must be greater than the minimum burst.
Repetitions:
Selectable in the range 1 to 100. The default value is 1.
This is the amount of times that the burst test will be repeated for each test frame size.
RFC2544 Burst Settings
Go back to top Go back to TOC
6.3.1.5 Starting/Stopping a RFC 2544 Measurement
Once all configurations have been made, tap the
Start
button on the right section of the screen to start the measurements.
Note: If testing on the fiber ports, make sure the LASER is turned On before starting the test.
The selected tests will run automatically. When all the tests are complete the test will stop automatically. If the RFC 2544 test suite needs to be stopped before they are
done, then simply tap the
Stop
button. The status of each selected test can be seen in the Results tab.
Go back to top Go back to TOC
6.3.2 Results
UX400 10G e-Manual D07-00-058P RevA00 Page 66 of 209