VeEX UX400, Руководство пользователя

Страница: 11 / 209

3.0 Safety Information
Safety precautions should be observed during all phases of operation of this instrument. The instrument has been designed to
ensure safe operation, however, please observe all safety markings and instructions. Do not operate the instrument in the
presence of flammable gases or fumes or any other combustible environment. VeEX Inc. assumes no liability for the customer's
failure to comply with safety precautions and requirements.
Optical Connectors
The UX400 displays a laser warning icon when the laser source is active to alert the user about a potentially dangerous situation.
It is recommended to:
1. Deactivate the laser before connecting or disconnecting optical cables or patchcords.
2. Never look directly into an optical patchcord or an XFP's or SFP’s connector interface while the laser is enabled. Even
though XFP and SFP optical transceivers are typically fitted with Class 1 lasers, which are considered eye safe, optical
radiation for an extended period can cause irreparable damage to the eyes.
3. Never use a fiber microscope to check the optical connectors when the laser source is active.
ESD: Electrostatic Discharge Sensitive Equipment
Test modules could be affected by electrostatic discharge. To minimize the risk of damage when replacing or handling test
modules, make sure to follow proper ESD procedures and dissipate any electrostatic charge from your body and tools and the
use proper grounding gear.
Perform all work at a workplace that is protected against electrostatic discharging.
Inserting, extracting, or handling test modules.
Never touch any exposed contacts, printed circuit boards or electronic components. - Connecting or disconnecting cables
from modules or platform.
Inserting or removing SFPs, XFPs, or CFPs from the platform.
Always store test modules in ESD protected packaging.
Safe Module Handling
While replacing test modules, all work on the open panel must be performed only by suitably qualified personnel who is familiar
with the dangers both to people and to the instrument itself.
Modules are not hot-swapable. The platform must be turned off and unplugged from VAC mains when removing or
inserting test modules.
For safety and EMC (Electromagnetic Compatibility), empty module slots must be properly covered with blank panel
covers.
Prevent foreign objects from entering the UX400, before, during and after module exchange or re-configuration process.
They could create short circuits or damage internal fans.
Always store test modules by themselves in individual ESD protected packaging (with no loose elements, like screws or
tools).
UX400 10G e-Manual D07-00-058P RevA00 Page 11 of 209