4
Installation Manual
Display Mounting
Units are designed to be mounted onto a bulkhead, dashboard, or panel. The method is
described below. The only required components are the mounting bracket and hardware.
Allow adequate clearance behind the display for cable connection (to ensure that the
cables are not unduly stressed), and for ventilation. Leave sufficient cable so that the
unit may be removed for servicing
Screw the threaded studs into the rear case
Carefully cut out the mounting hole, templates are available upon request if required
Place the CANvu Display in position, use the mounting bracket and™ thumb nuts to
secure the units. The thumb nuts should only be hand tight
In the correct order connect the Deutsch mating connector harness into the housing,
ensuring it is fully seated
1. Mounting the display
Instructions
WARNING:
Do not over tighten the studs/thumb nuts and don’t use metal
screws as they may damage the unit and void the warranty.
