Veeder-Root TLS-50 Series, Настройка и эксплуатация

Страница: 16 / 116

TLS-50 Setup Communications Setup
13
Communications Setup
The Communications Setup procedure allows you to select whether system status and tank reports are sent to a
remote printer or transmitted via modem or direct connection to a computer.
SELECT THE COMMUNICATIONS SETUP MENU
From the Top Display Menu, scroll to the Communications Setup display. Make changes as required following
options shown in Figure 8.
Figure 8. Communications Setup Menu
consoles\tls50\50com1.eps
COMMUNICATIONS SETUP
BAUD RATE: 9600
COMMUNICATIONS SETUP
PARITY: NONE
COMMUNICATIONS SETUP
HANDSHAKE:
XON/XOFF
COMMUNICATIONS SETUP
PRESS
Use this display to select communication options of
Printer, Modem, or Serial. Note: if you select modem, an
auto-answer command will be sent to the modem when
the setup menup is exited.
AVAILABLE WITH SERIAL PACKAGE OPTION ONLY.
Choose the baud rate that matches the external device
connected to the console. Options are 300, 600, 1200,
2400, 4800, or 9600.
Choose the parity that matches the external device
connected to the console. Options are None, Odd, or
Even.
COMMUNICATIONS SETUP
DATA LENGTH: 8
Choose the data length that matches the external device
connected to the console. Options are 8 or 7 (must be
set to 8 for printing)
COMMUNICATIONS SETUP
STOP BIT: 1
Choose the number of stop bits that match the external
device connected to the console. Options are 1 or 2.
Continued on next page.
COMMUNICATIONS SETUP
TYPE: PRINTER