Veeder-Root TLS-350 Series, Руководство по установке

Страница: 15 / 29

TCP/IP Interface Module Installation Connect a PC or Laptop to the TCP/IP Interface Module
11
4. After confirming a successful link between the PC and the TCP/IP module, proceed to the either the IP
Address/Configuration section using Telnet or using a browser as desired.
CONNECTING TO THE TCP/IP INTERFACE MODULE DIRECTLY
1. Connect the laptop to the TCP/IP Interface Module as shown in Figure 9. Insert the RJ-45 plug of the ethernet
crossover cable into the RJ-45 connector in the end plate of the TCP/IP Interface Module.
Important! you must use an ethernet crossover cable.
2. Locate the 2 LEDs on the top edge of the RJ-45 connector on the module’s end plate (see Figure 8 on
page 10).
3. Depending on the network card installed in the laptop, the left or right LEDs on the top edge of the RJ-45
connector should remain ‘On’ when a proper connection is made as shown in Table 3.
4. Before entering the TCP/IP Interface Module’s IP Address enter a static IP Address in your connected laptop.
IP Address setup procedures for both Windows 7 and 10 are discussed in this section.
Setting Your PC’s IP Address for Direct Connect (Windows 7 and 10)
1. Connect your laptop to the TCP/IP card as shown in Figure 9 above. Go to your laptop’s Control Panel folder
and select Network and Internet to display the Network screen (Figure 10):
Off Blinking green 100Base-T full-duplex; activity
Solid amber Off 10Base-T half-duplex link
Blinking amber Off 10Base-T half-duplex; activity
Solid green Off 10Base-T full-duplex; link
Blinking green Off 10Base-T full-duplex; activity
Legend For Numbered Boxes In
Figure
9
1. Plugs into RJ45 Ethernet
Adaptor in Laptop
2. Laptop
3. You MUST use an Ethernet
crossover cable!
4. Plugs into RJ45 connector in
end plate of TCP/IP module
5. Tank Gauge
Figure 9. Direct connect using ethernet crossover cable
Table 3. Network Connection/Activity LED Codes (ref. view in Figure 8)
Left LED Right LED Meaning