8
DIS-51 To TLS Console Wiring Connections
This section includes instructions for configuring the jumpers and serial ports and
setting up the software for applicable TLS Consoles. Instructions are specific to
each console type.
Connection Instructions - DIS-51 to TLS2P
RS-485 Serial Port Configuration On TLS2P
Set jumper J3 onto pins 1 and 2 for 2-wire configuration (see Figure 4).
Figure 4. Serial Port Configuration For TLS2P
1.
Attach the RS-485 cable from the DIS-51 to TLS2P Serial Port 2 connector
(J8) as shown in Figure 3.
2.
Only one terminal connector (J8 or J9) can be in use at one time. J9 is for RS-
232 only.
Содержание DIS-51
