2
R
5
6
7
8
4
3
2
1
O V E R V I E W
OPERATION
VEEDER-ROOT
1. Total Display
2. Down Key
3. Next/Reset Key
12345678
VEEDER-ROOT
3. Next/Reset Key:
If the total value is being displayed depressing
this key will cause the value to be reset to 0. When the program input
is active this key is used to select a menu item for editing (left most
digit will begin to flash) and then move to the desired digit to be
changed.
1. Total Display:
Indicates the present count value, which is equal to
the number of pulses received (since the last reset) multiplied by the
Count Input Calibrator in Program mode.
2. Down Key:
When the program input is active this key is used to
scroll through the menu items. After a menu item has been chosen for
editing, the down key is used to set the value for the currently selected
(flashing) digit.
REAR TERMINAL CONNECTIONS
* For high speed current sinking devices, provide a pull-up
resistor from terminal 2 to a DC source
1. Common
2. High Speed Input A - PNP or squre
signals up to 10 kHz* for incrementing the
count value
3. Low Speed Input A - NPN or dry contact
inputs up to 30 Hz for incrementing the
count value
4. Remote Reset - Resets count value when
switched to common
5. Front Panel Program Enable - Allows access to
program mode when tied to common
6. Low Speed Input B - NPN or dry contact inputs up
to 30 Hz for decrementing the count value
7. High Speed Input B - PNP or squre signals up to 10
kHz* for decrementing the count value
8. DC Supply Input - For backlighting
Refer to wiring
for terminal 3
Refer to wiring
for terminal 2
+
-
10 - 28 VDC
+
-
