9
section 2.7 (on P13) and professional installation instructions on P15 of this user manual for detailed antenna
information and installation requirement.
2.5 Trace antenna designs
Not applicable.
2.6 RF exposure considerations
This equipment complies with FCC mobile radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20cm
between the radiator & your body. If the module is installed in a portable host, a separate SAR
evaluation is required to confirm compliance with relevant FCC portable RF exposure rules.
2.7 Antennas
The following antennas have been certified for use with this module; antennas of the same type with equal or lower gain may
also be used with this module. The antenna must be installed such that 20 cm can be maintained between the antenna and
users.
Model
Antenna Gain
(dBi)
Frequency range
Antenna Type
Connecter Type
*Cable Length (mm)
MFB9153
3
902-928 MHz
Dipole
N Female
1169.4(Outdoor)
1014.4(Indoor)
MFB9155NF
5
902-928MHz
Dipole
N Female
1169.4(Outdoor)
1014.4(Indoor)
MPAMB700MSMA
2
698-960 MHz
Dipole
SMA Male
100
ET915NPMR
2.7
902-928 MHz
Dipole
N Male
255
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following: “Contains FCC ID:
2ARXKRG1008M
”. The grantee's FCC ID can be used only when all FCC compliance requirements are
met.
2.9 Information on test modes and additional testing requirements
This transmitter is tested in a standalone mobile RF exposure condition and any co-located or
simultaneous transmission with other transmitter(s) or portable use will require a separate class II
permissive change re-evaluation or new certification.
2.10 Additional testing, Part 15 Subpart B disclaimer
This transmitter module is tested as a subsystem and its certification does not cover the FCC Part 15
