Vectrix VX-2 2011, Руководство по обслуживанию

Страница: 46 / 99

VECTRIX VX-2 SERVICE MANUAL
Regen Throttle Position Checking Procedure
S-RW-100000
Without PC
Note: This procedure is to be used when a PC is not available. This adjustment MUST be
verified using the PC method.
1. Place the ignition key in the ON position and the kill switch in the ON (non-run) position.
2. Squeeze the left side brake lever and observe the speedometer needle (1). This reading is
the actual setting of the Regen Throttle.
3. Continue to squeeze the left side and then squeeze the right side brake lever and observe
the speedometer needle. This is the required setting and what the actual reading in Step 3 must
be set to. If the settings are not the same refer to Throttle Adjustment Procedure.
(1)
With PC
1. Connect the Diagnostic Hardware. Refer to Diagnostic Hardware Connections.
2. Open the Vectrix diagnostic program, by clicking on the ScooterDiag icon. This will open up
the Scooter Diagnostics Summary page.
3. Within the General Information box, click on the “Show Instrument” button. This will open up
an instrument cluster page.
4. In the lower center of the page is the throttle setting. This setting color should be in the
Green, if the color is Red, the throttle is out of adjustment and must be adjusted. Refer to
Throttle Adjustment Procedure.
Version 1.0/May 2011
VECTRIX, LLC