V
E C TO R
Q
UA D S
6. Mount the
Servo Mount Frame
onto the
base plate using two
Flat Head Phillips
Screw 9mm Length
. Do not over tighten
screws.
7. Mount the tail
Servo Mount Frame
onto
the base plate using two
Pan Head
Phillips Screw 9mm Length
. Do not
over tighten screws.
8. Assemble
the
Motor Mount
onto the ends of the tubes using a
Motor
Mount Clamp
and two
Socket Head Cap Screw M2.5x0.45x16
. Align
the locating pins on the clamp and mount to the guide holes on the tube.
IMPORTANT: Do not completely tighten one screw, then the other.
Tighten each screw a little at a time to avoid putting too much stress on
one side of the tube. Tighten screws just enough to remove any play on
the motor mount.
Note that due to the tube length and frame size, 5 inch props are the
max size that can be used with this frame.
Do not install motors at this time. Simply choose the orientation of the
motor mounts based on the intended motor size you plan to use.
For 1806 18mm diameter motors, install
inside the motor mount. Use supplied
washers with screws to mount the motors.
For a stator diameter larger than 18mm,
rotate the motor mount upside down and
install motors on the bottom side.
