Vector START-IT MAXX VW022APC, Руководство пользователя и гарантия

Страница: 11 / 16

11
5. EMERGENCY WORKLIGHT
The worklight is controlled by an On/Off switch. Make sure the lamp is turned OFF
when the unit is being recharged or stored. The lamp is efficient and will operate up to
114 hours on a full charge. The CCFL lamp’s operating life is 100,000 hours.
6. AIR COMPRESSOR/TIRE INFLATOR
IMPORTANT:
Read Instructions Carefully To Avoid Possible Injury Or Property Damage.
The built-in 12 volt DC air compressor is the ultimate compressor for all vehicles, trailer
tires and recreational inflatables. Three different sized nozzles are supplied. Each
nozzle will clip on the end of the standard tire valve connector located at the free end
of the compressor hose. The compressor nozzles are stored inside the hose hatch. The
compressor hose with tire fitting is stored in a retaining channel between the jumper
cable channels on the rear of the unit. The ON/OFF Switch is located on the side of
the main unit near the AC recharge port. The compressor can operate long enough to
fill up to 3 average sized tires before the battery must be recharged.
The compressor may be used by removing the air hose from the storage hatch and if
required, fitting an appropriate nozzle to the air hose. An ON/OFF switch located on
the side of the unit controls the power to the compressor and the gauge light. Refer to
Figure 3 for locations of compressor hose, nozzle storage hatch and hose. Return hose
to the storage compartment after use.
6.1 WARNINGS FOR COMPRESSOR USE
The compressor is capable of inflating up to 260 pounds per square inch (PSI)
pressure. To avoid over-inflation, carefully follow instructions on articles to be
inflated. Never exceed recommended pressures. Bursting articles can cause
serious injury. Always check pressure with the pressure gauge. Never leave
compressor unattended while in use. Allow unit to cool after 10 minutes of
continuous operation.
COMPRESSOR
HOSE AND
CHUCK
STORAGE HATCH
FOR HOSE AND
ADAPTERS
INFLATION
ADAPTERS
(NOZZLES)